PowMr MPPT Solar Charge Controller 60A 80A 12V 24V Automatic Solar Panel Regulator for Max 50V Input All-in-One Monitor L60 L80
- 1. Equipped with installation tools, materials and cables, please match the appropriate cables.
- 2. Install the controller and fix it on a vertical plane. Check the installation hole diameter and hole spacing of the V section to ensure good heat dissipation conditions for the controller. The 10.cm area at the bottom of the controller is reserved
- 3. According to the correct wiring sequence: the load, battery, and solar panel are connected to the controller to be operated respectively, and the positive and negative polarity of the load, battery, solar panel, and controller are ensured.
- 4. Before use: place the external temperature sensor probe on the left side of the interface probe, and place the controller temperature probe at a place close to the temperature of the battery. (The extension line must have a built-in external temperature probe device, otherwise the controller will control the error temperature compensation parameters.
- 5. Warning: To prevent accidents, installation: Non-professionals are not allowed to perform loading and unloading operations.
troubleshooting:
The polarity of the solar panel cable is installed incorrectly (“+”-), just remove the polarity and reinstall it.
If the rated power of the solar panel is exceeded, the second reduces the discharge problem of the solar panel power not exceeding the rated power controller.
Remove the wrong load connected to the load and reinstall the correct load.
If the load power exceeds the rated power, reduce the load power of the controller to not exceed the rated power.
The instantaneous start-up current is too large, the battery capacity is too small, replace the battery with high capacity, and the button troubleshooting
If the terminal is too loose or too square, increase the size of the USB cable and tighten it.
All buttons can fix errors, and long press for 5 seconds can restore factory settings.
Key Features
- The polarity of the solar panel cable is installed incorrectly (“+”-), just remove the polarity and reinstall it.
- If the rated power of the solar panel is exceeded, the second reduces the discharge problem of the solar panel power not exceeding the rated power controller.
- Remove the wrong load connected to the load and reinstall the correct load.
- If the load power exceeds the rated power, reduce the load power of the controller to not exceed the rated power.
- The instantaneous start-up current is too large, the battery capacity is too small, replace the battery with high capacity, and the button troubleshooting
- If the terminal is too loose or too square, increase the size of the USB cable and tighten it.
- All buttons can fix errors, and long press for 5 seconds can restore factory settings.
What’s in the box
- 1 x Solar Controller
- 1 x User Manual
Specifications
- SKU: PO442GP4WTRC8NAFAMZ
- Product Line: PowMr
- Model: L60,L80
- Production Country: China
- Size (L x W x H cm): 21 x 14.2 x 7.6
- Weight (kg): 0.75
- Shop Type: Jumia Mall
Help Center